Klaus92 Posted January 19 Share Posted January 19 NIck Jenkinson TD47921 UK Garrison Klaus92 https://www.501st.com/forum/memberlist.php?mode=viewprofile&u=25552 HI Here is the link to my pictures: https://postimg.cc/gallery/y9Y7K5k Quote Link to comment Share on other sites More sharing options...
bigwam Posted January 20 Share Posted January 20 Hello Nick, Thank you for your inquiry. Please post your pictures here directly in the thread and not via a link, that makes it easier for everyone. Please also make sure to post the images in a good size and resolution And: Please note the requirements on how to submit an application and which images are necessary. You can find examples in other applications and the corresponding requirements here: https://forum.mepd.net/index.php?/topic/16077-attention-new-po-crl´s-for-td-valid-from-11212022/ 1 Quote Link to comment Share on other sites More sharing options...
bigwam Posted January 20 Share Posted January 20 you can do it with, for example, with www.postimages.org Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted January 22 Author Share Posted January 22 (edited) Cod piece rivet Side snap Other side brass rivets Kidney plate Brass rivets chest fixings left side view (new pouch now fitted) Left, arm up (new side pouches now fitted) Back shot Right view Right view arm up ( new pouch now fitted front with DLT Front with dlt Action pose Lid off shot Back New side pouches now fitted New pouch for shoulder Edited January 22 by Klaus92 New photos, with description Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted January 22 Author Share Posted January 22 On 1/20/2024 at 10:23 AM, bigwam said: you can do it with, for example, with www.postimages.org Hi Thomas Thank you, that seemed a lot more difficult than it actually was!! If you need anything further, please let me know! Quote Link to comment Share on other sites More sharing options...
bigwam Posted January 23 Share Posted January 23 Hello Nick, I'm glad it still worked. Yes, some pictures are still missing. Please take a look at the link I included above. It describes which images are needed. A little tip: Tighten the belt a little and there will be no problems with the gap. And please attach the correct pouch to the armor. I'm looking forward to more pictures, Thomas Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted March 18 Author Share Posted March 18 Painted details Green lenses Cod piece side rivets chest bolts side side arms up back side front action Lid off New side pouch Pack pouch Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted March 18 Author Share Posted March 18 Just awaiting some prestuds for the shoulder and some new gloves with rubber armour details on the back of the glove Quote Link to comment Share on other sites More sharing options...
bigwam Posted March 23 Share Posted March 23 Hello Nick, I am pleased to see your application. Let's see if everything is correct and meets the requirements of a PO: Application Review: Part 1 Name: Nick Jenkinson Legion ID: TD-47921 Forum Name: Klaus92 Garrison: UK Garrison Helmet a. Green lenses: check b. Paint color of traps / tears: check c. Correct number of teeth: check d. Mic tips: check e. Vocoder color: check f. Tube stripes: check g. Rank bar on ears: check h. Brow: check i. Side screws (ears): check j. Weathering: check k. no mesh behind teeth: check RESULT ON HELMET Checked & Cleared Armor details The Armor Pics are to small, i can see no details. Please post bigger Pics of them. Backpack The Backpack Pics are to small, please post bigger Pics of them. Weapon: E-11 no pictures available Hello Nick, the images cannot be enlarged. Please post images in a larger resolution. Various detailed images are also still missing - please note the list of details that are required. Thanks. To set the images you can use providers such as https://postimages.org/ to use. Best regards, Bigwam Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted March 28 Author Share Posted March 28 Side snap Other side brass rivets Kidney plate Brass rivets chest fixings New side pouches now fitted New pouch for shoulder E11 ( aluminium main body, 3d cast parts) Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted March 28 Author Share Posted March 28 Tired to make them as big as possible!! i also have an SDS e11 Ill send pics for you Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted March 28 Author Share Posted March 28 Quote Link to comment Share on other sites More sharing options...
bigwam Posted March 29 Share Posted March 29 OK Nick, Now, the pics are big enough. Now I can see everything that is important for acceptance. Application Review: Part 2 Name: Nick Jenkinson Legion ID: TD-47921 Forum Name: Klaus92 Garrison: UK Garrison Helmet a. Green lenses: check b. Paint color of traps / tears: check c. Correct number of teeth: check d. Mic tips: check e. Vocoder color: check f. Tube stripes: check g. Rank bar on ears: check h. Brow: check i. Side screws (ears): check j. Weathering: check k. no mesh behind teeth: check RESULT ON HELMET Checked & Cleared Armor details a. elastic straps shoulders: check b. neck seal: check c. black undersuit: check d. shoulder bells: check e. biceps: check f. forearms: check g. pauldron: check h. chest / back plate: check i. kidney / butt plate: check j. ab plate / side rivets / cod: read comments k. strapping system: check l. thighs: check m. shins / calves: check n. sniper plate: check o. boots: check p. gloves: check q. hand plates / guards: check r. ammo belt (waist): check s. ammo belt (right knee): check t. canvas belt: check u. pouches: read comment v. weathering: check RESULT ON ARMOR pending Comments: Point 1: It's about the gap on the side. According to the CRL for Level 2, it cannot be larger than 1/2 inch: Armor side gaps are closed or nearly closed: No more than 1/2 inch (12,7 mm) gap on either side This is done by adding a shim (or shims) of a similar type and colour of material as the Abdomen and back Armor Shims fit flush, ideally they will be seamless to the Abdomen and/or Back Armor, resulting in a single seam between the two rather than extra seams where the shims are joined. Maybe you can tighten the belt a little for the photos. A little tip: if you don't lift your arms up when taking photos, but slightly forward, then the gap won't open up as much. Point 2: Your pouches. You have the correct ones pictured, but the wrong ones are hanging on the costume. The right pouches should be appropriate, especially for action pictures. Please say no again. Please make sure that the sticker on the shoulder bell is not visible in the action picture. According to the CRL, stickers are not allowed (I know the background at the UKG when it comes to stickers, but please note) Backpack a. details: check b. weathering: check RESULT ON BACKPACK check and cleared Weapon: E-11 a. details: check b. weathering: check RESULT ON WEAPON Checked & Cleared OK Nick, these are small but quickly fixable points that still need to be changed. Everything else fits. Level 2 is all about being as close as possible to the film model, so you have to pay attention to even the smallest details. I am convinced that you will fix this as quickly as possible and submit the new pictures (from the front and side and the action picture with the other pouches and the closed gap - which has certainly just slipped) then nothing will stand in the way of Level 2. Best Regards, Bigwam Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted April 1 Author Share Posted April 1 Great I’ll try and sort that as soon as possible, thank you Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted April 15 Author Share Posted April 15 Quote Link to comment Share on other sites More sharing options...
bigwam Posted April 16 Share Posted April 16 Good Morning Nick, Let´s go! Application Review: Part 3 Name: Nick Jenkinson Legion ID: TD-47921 Forum Name: Klaus92 Garrison: UK Garrison Helmet a. Green lenses: check b. Paint color of traps / tears: check c. Correct number of teeth: check d. Mic tips: check e. Vocoder color: check f. Tube stripes: check g. Rank bar on ears: check h. Brow: check i. Side screws (ears): check j. Weathering: check k. no mesh behind teeth: check RESULT ON HELMET Checked & Cleared Armor details a. elastic straps shoulders: check b. neck seal: check c. black undersuit: check d. shoulder bells: check e. biceps: check f. forearms: check g. pauldron: check h. chest / back plate: check i. kidney / butt plate: check j. ab plate / side rivets / cod: check k. strapping system: check l. thighs: check m. shins / calves: check n. sniper plate: check o. boots: check p. gloves: check q. hand plates / guards: check r. ammo belt (waist): check s. ammo belt (right knee): check t. canvas belt: check u. pouches: check v. weathering: check RESULT ON ARMOR check an cleared Comments: The gap on the side is still a bit borderline, but if you tighten the belt a little more, it becomes smaller. Backpack a. details: check b. weathering: check RESULT ON BACKPACK check and cleared Weapon: E-11 a. details: check b. weathering: check RESULT ON WEAPON Checked & Cleared Nick, this was the third and last Review. Congratulations - Your armor has reached level 2 and you can now proudly wear the title "Police Officer". You have successfully followed the guidelines in regards to the MEPD CRL and have met the requirements, be proud of yourself. Now, you are a member of the Police Officers, the Elite Troopers of Tatooine! Please send the pic you want to use to Luis (Sandman Tigui) and we'll get you squared away. We will have your updated information uploaded into the MEPD system very soon. Congratulations on becoming a Deployed Officer of the MEPD! Now please report to the Mos Eisley Mess hall where you'll serve the troopers until the next newbie gets cleared. Bigwam - MEPD Deployment Officer 1 Quote Link to comment Share on other sites More sharing options...
Vf2112 Posted April 16 Share Posted April 16 Congratulations nick nice work 1 Quote Link to comment Share on other sites More sharing options...
Klaus92 Posted April 16 Author Share Posted April 16 Thats Brilliant!! Thanks so much, really appreciate your help! Thank you! Quote Link to comment Share on other sites More sharing options...
Hausi Posted April 17 Share Posted April 17 Congrats Quote Link to comment Share on other sites More sharing options...
IronBronson Posted April 19 Share Posted April 19 Congratulations! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.