bigwam 449 Posted September 8, 2018 Before i can start the last part of the review, please show me new pics from the armor from all sides. I see, you have done something on the weathering. It is not so heavy/strong like on your first pics. But please - show me new pics from the armor and all details. Thanks Kainan! Quote Share this post Link to post Share on other sites
TD 9366 7 Posted September 11, 2018 Thank you Thomas! Fixing the elastic band and adding some close up pic of the armor... And about the cyphon on the backpack, I wonder if it's acceptable to shorten mine by 2.5cm? Looking forward to some suggestions! Quote Share this post Link to post Share on other sites
bigwam 449 Posted September 12, 2018 Hi Kainan, Thanks for the new pics. I will do my best in the next time. Note: no cable ties on the siphon! It makes sense to cut the old one? Quote Share this post Link to post Share on other sites
TD 9366 7 Posted September 12, 2018 2 hours ago, bigwam said: Hi Kainan, Thanks for the new pics. I will do my best in the next time. Note: no cable ties on the siphon! It makes sense to cut the old one? Actually it is a Gordon ciphon, maybe I can remove the cable ties and have it upgraded? I tried to look for a Shire UP90 replica but have found nothing... if anyone have resources please PM me... Quote Share this post Link to post Share on other sites
bigwam 449 Posted September 19, 2018 Kainan thanks for the new pics. There are some things, i have seen on the armor. Some little difference on the weathering: Look at the breast plate (Pic 1). And there are some distinctive points on the belt and the Abdomen. It seems as if the belt has slipped down and there is no weathering on the Abdomen (Pic 2). A few small things but they are typical for the Move along Captain. Is it also possible to get some Pics from the right side of the right tigh? And Please the whole armor from all sides. Thanks so much! 1 Quote Share this post Link to post Share on other sites
TD 9366 7 Posted September 25, 2018 Thanks a lot Thomas, I'll start working soon. Here is the photo of the right side of right thigh. And also whole armor photos from all side. Let me know if you need more detailed pics. Quote Share this post Link to post Share on other sites
TD 9366 7 Posted September 26, 2018 OK Thomas, I've made some fix on my bucket, here are the new pics: And some more pics from the same angle as the movie snap for your review: Looking forward to your comments! Quote Share this post Link to post Share on other sites
bigwam 449 Posted September 27, 2018 Hello Kainan, absolutelly great work! The most of the weahering points are done. But there are two or three things: i miss some little points and look at the teeth, they are cut out a bit further. These little points to do and the helmet is perfect for me. Quote Share this post Link to post Share on other sites
TD 9366 7 Posted September 28, 2018 Hi Thomas, did some further work according to your review, please let know if I'm doing it right. Quote Share this post Link to post Share on other sites
bigwam 449 Posted October 1, 2018 Kainan, great work, i like it! Helmet Green Lenses: check Paint Color on Traps / Tears: check Paint Color and Number of Teeth: check Mic Tips: check Vocoder Color: check Tube Stripes: check Rank Bar: check Brow: check Side Screws (ears): check Weathering: check Specials (ears): check **Additional comments** check and cleared One thing is to say about the mic tips. Please look, they are a little bit skew. It looks better and more accurate . Quote Share this post Link to post Share on other sites
TD 9366 7 Posted October 8, 2018 Thank you for your suggestion. Mic tips adjusted. I'm waiting for my new backpack parts to arrive, will proceed my work soon! 1 Quote Share this post Link to post Share on other sites
bigwam 449 Posted October 9, 2018 Great! I like it! Quote Share this post Link to post Share on other sites
devilmonking 0 Posted December 30, 2018 2019 加油 Quote Share this post Link to post Share on other sites
TD 9366 7 Posted December 31, 2018 17 hours ago, devilmonking said: 2019 加油 Thanks bro. 2018 was a busy year for me but I won’t give up. I will be back soon! Wish you a happy new year! Quote Share this post Link to post Share on other sites
SID 16 Posted February 10, 2019 Good direction . Quote Share this post Link to post Share on other sites
TD 9366 7 Posted April 7, 2019 Hi Thomas I'm back! Sorry for the long absence... it has been a really busy and tough year, and I finally made some time to proceed my work. Here we go... Whole view: bottles shortened and position adjusted, mushroom cups changed to rubber cups from toliet plungers: new syphon: right side of the pack: mortar tube face plate re-cut: mortar tube glue spot added: tape position adjusted: bigger gap between the shotgun shells: black Gio bottle holder: Left side: scratches on the frame, bigger kink in the karrimor frame, blue/grey colour on the brexton box, red leftovers on the crossbelt of the karrimor frame, radio position adjusted: I know you have mentioned that there are only two tapes on the left side of the lower part. But after thinking it over, I believe there was a third tape like the pic below: Please tell me whether I'm right. leather straps on the bottom of the radio:https://i.loli.net/2019/04/07/5caa0f95c105b.jpg Although there were some difficulties for me, but like I said, I'll never give up on this project. Looking forward to your review! 1 Quote Share this post Link to post Share on other sites
Hausi 505 Posted April 7, 2019 Hey Kainan, good to see you're back! Great attention to details. Quote Share this post Link to post Share on other sites
bigwam 449 Posted April 8, 2019 Kainan, welcome back! Nice to see your built again! Kainan, you are right. There is a third tape on the box! Absolutely great to see this, i haven´t!!! Let me say, this pack is absolutely great. Details, work - i´m speekless! So, let´s start the review for the Backpack: Name: Kainan Zhu Legion ID: 9366 Forum Name: TR9366 Garrison: Chinese Garrison ANH Santrooper selected: Road Block Captain Move along Backpack Details: check and cleared! Weathering: check approved! Weapon: E-11 Tunisia Blaster Details: check Weathering: check **Additional Comments** **RESULT ON WEAPON** approved! Another point is done, congratulations! Best Regards, bigwam Quote Share this post Link to post Share on other sites
jcalus 52 Posted April 8, 2019 Nice work! Well doneSent from my SM-G930W8 using Tapatalk Quote Share this post Link to post Share on other sites
TD 9366 7 Posted April 9, 2019 Great! Thank you Thomas! I will proceed to the armor weathering part asap! Quote Share this post Link to post Share on other sites
TD 9366 7 Posted April 11, 2019 Thomas, thank you for your previous suggestions, now I have done my armor weathering work. Here are some new pics for you to review: Front: Left: Right: Chest armor close up Ab plate close up Right side of right thigh close up Belt close up, adjusting the button position (But I found no photo for the button on the other side, so I have it unchanged. Wonder if anyone have more reference pics?) After studied all the reference pics you provided, I have some questions: There were two versions roadblock cpt: Ver 1: 1. Right shoulder bell attached tightly, fitting the actor's shoulder 2. Equiped with MP40 leather pouches Ver 2: 1、Right shouler bell slipped down to the elbow and fixed by a black tape 2、Equiped with a medium Spanish pouch My armor now is ver 1, do I have to make both versions for SWAT? If so I can make my shoulder bell adjustable and get myself a new pouch. (Not sure if there are more differences between these two versions, please point it out if I missed something. Thanks again! 1 Quote Share this post Link to post Share on other sites
Hausi 505 Posted April 13, 2019 Hey Kainan, I think your weathering looks very promising and a good choice to go with mainly black colours. Some of the details of the chest might have to be adjusted but overall it really looks great. I think it's okay to have only one version, no need to have both but that's something I will have to talk about with Bigwam. I really like your attention to detail, e.g. the little button plate on the belt. Have a look at some pics of the original right thigh, especially at the top, there you can clearly see that one side is longer where the two halves are joined by the coverstrip. Man, it's really cool seeing your progress, keep up the good work, you will be a very worthy addition to the ranks of the SWAT officers! Quote Share this post Link to post Share on other sites
TD 9366 7 Posted April 13, 2019 Thank you Hausi! That's really helpful! Quote Share this post Link to post Share on other sites
bigwam 449 Posted April 14, 2019 Great Pics Kainan! Please give me some time to view them. Quote Share this post Link to post Share on other sites
bigwam 449 Posted April 18, 2019 Ok Kainan, let´s go! First, let me say - I am thrilled about your work, a big leap forward! Before we cross the finish line, I have a few small points that we noticed but are very easy and quick to fix: There are some spots, where i miss some distinctive points: The pouch: Please blacken the cut edges and give the pouch a crumpled look. Watch out for the kink. One last thing. Is it possible to restore this detail? If it is not possible and you need a new piece of armor for it, leave it. If you can restore it, ok. Kainan, a few little things left. I can already smell the fragrance of the SWAT! For the final picture please show us the armor again completely dressed, please not on the display. Best Regards, bigwam. Quote Share this post Link to post Share on other sites