ECOLI Posted October 17, 2011 Share Posted October 17, 2011 Hey Guys, Does anyone have some good ideas on how to attach the sniper plate? I have been brainstorming some ideas and wanted to see what everyone else has done. Thanks. Quote Link to comment Share on other sites More sharing options...
supa troop Posted October 17, 2011 Share Posted October 17, 2011 im going to hot glue my diamond knee plate straight onto the exsisting knee plate and then attach with good old fashioned pop rivets to the calf piece Quote Link to comment Share on other sites More sharing options...
Grit Posted October 17, 2011 Share Posted October 17, 2011 use a glue that will weld the shin and the knee plate together probs the same glue you use for the entire billed Quote Link to comment Share on other sites More sharing options...
iconoclasta_88 Posted October 17, 2011 Share Posted October 17, 2011 I just glued it with E6000. Used some plastic pieces fixed on the back on the top of the shin to make the kneeplate stay away and not tucking into the thigh. There is also a tutorial by Pandatrooper on a great more elaborated solution for this. I will try and locate it for you in a min. Saludos Quote Link to comment Share on other sites More sharing options...
iconoclasta_88 Posted October 17, 2011 Share Posted October 17, 2011 Ok. Here it is. Hope it helps. http://forum.mepd.net/index.php?showtopic=6775 Saludos Quote Link to comment Share on other sites More sharing options...
ECOLI Posted October 18, 2011 Author Share Posted October 18, 2011 Hey that worked great thanks for the replies, also since I am getting near the end I did a test fit last night and my rear end is poking out, it looks pretty funny Anyway does does anyone have a remedy or possible cause I think my groin snap is too tight pulling it way forward but I am not sure...Any tips would be great. Quote Link to comment Share on other sites More sharing options...
DirtyBoy Posted October 18, 2011 Share Posted October 18, 2011 I used 3M double sided tape to attach mine....sounds crazy but I wanted the ability to move if needed. Quote Link to comment Share on other sites More sharing options...
Grit Posted October 18, 2011 Share Posted October 18, 2011 do you have any photos? Quote Link to comment Share on other sites More sharing options...
DirtyBoy Posted October 18, 2011 Share Posted October 18, 2011 My swat submission....it's 2 layered to give proper clearance. My weathering is also completely washable so I can remove the sniper, rinse off the weathering with soap And water.....now I've got a tk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.