Rolf Posted March 29, 2008 Share Posted March 29, 2008 I have the HF MG34, modify to DLT-19. But i still need to add the handle. I think i will use some black hips left over, from the MH/SB kit. Cut it out, and add a pvc pipe on it. What do you think, any ideas . Quote Link to comment Share on other sites More sharing options...
trooper1 Posted April 8, 2008 Share Posted April 8, 2008 Hey, On mine I used a piece of half inch metal pipe, cut at an angle with a dremel. Used piece of aluminum, for inset, and drilled a hole for the handle. Used a long sheet metal screw, put in part way, then covered in plastic welder. Put handle piece on and then filled with epoxy resin, (plastic welder), made it solid as rock. Screw and pipe became one. Jay Quote Link to comment Share on other sites More sharing options...
Rolf Posted April 8, 2008 Author Share Posted April 8, 2008 Hey, On mine I used a piece of half inch metal pipe, cut at an angle with a dremel. Used piece of aluminum, for inset, and drilled a hole for the handle. Used a long sheet metal screw, put in part way, then covered in plastic welder. Put handle piece on and then filled with epoxy resin, (plastic welder), made it solid as rock. Screw and pipe became one. Jay Looks very good trooper1. You have done a very great job there. I might do the same . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.