bdgr Posted August 5, 2014 Share Posted August 5, 2014 Does anyone have a recommendation for the sniper knee piece depth? What is the depth length that most folks are trimming to? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
Allerg3n Posted August 5, 2014 Share Posted August 5, 2014 Hey Eric! You'll hopefully be getting a set of submission pics for me soon. :-D I trimmed mine to about half an inch thick, just going anecdotally based on guesstimates from other peoples' build threads and what I could find online. Mine came out a bit sloped - it's thicker towards the bottom and thins out on top. I initially trimmed the piece I got from my ATA kit, which was hollow, then filled it with two layers of foam board and cut an ABS back for it. Can take pics if you'd like. It's not the slickest knee plate out there, but it looks banged up and dirty. Some more experienced members here may have a more precise answer, though. Best of luck! Hope to meet you at a troop soon. Quote Link to comment Share on other sites More sharing options...
trooper1 Posted August 6, 2014 Share Posted August 6, 2014 Hmm, Eric. I can dig mine out in the morning and get a measurement for you. I don't recall exact. 3/8" to 1/2" sounds about right but will check to be sure. It's always easy to take some off, but almost impossible to put it back! Lol Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.