HeloTrooper Posted July 3, 2012 Share Posted July 3, 2012 I have the thermal detonator panel from an old FX kit, but it's just a bit wrong on the diameter for the mortar tube. I figure that if I can heat it up enough, I could bend form it around the tube, and reshape it accordingly. Has anyone tried this? Does anyone know if it can be heated and adjusted safely? Another question would be, if this doesn't work, is anyone making control panels that will fit the mortar tubes (in this case one of DirtyBoy's)? Thanks! - Andy Quote Link to comment Share on other sites More sharing options...
inglorious trooper Posted July 3, 2012 Share Posted July 3, 2012 i heated one a long time ago,i did it gently from the inside! Quote Link to comment Share on other sites More sharing options...
HeloTrooper Posted July 3, 2012 Author Share Posted July 3, 2012 With a heat gun or blow dryer or...? Quote Link to comment Share on other sites More sharing options...
DirtyBoy Posted July 3, 2012 Share Posted July 3, 2012 Should have no problem with either one...just don't overheat because the details will warp Quote Link to comment Share on other sites More sharing options...
inglorious trooper Posted July 4, 2012 Share Posted July 4, 2012 did it with a hair dryer,it took some time but worked! Quote Link to comment Share on other sites More sharing options...
DirtyBoy Posted July 11, 2012 Share Posted July 11, 2012 sweet....i guess hair dryers are good for something Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.