Brody Posted May 23, 2013 Share Posted May 23, 2013 I am working on an ATA helmet, and planning on using the Pandatrooper tube stripe templates, the problem is I was wanting to do the "move along trooper" and I am trying to figure out how I can get the correct amount of tube stripes for that character. It just does not seem like there will be able to be 16 stripes on the left side. Please help, I am so stuck right now. Quote Link to comment Share on other sites More sharing options...
Clue Posted May 24, 2013 Share Posted May 24, 2013 Maybe you can pick Smallys brain. He put together a beautiful Move Along. Good Luck. Quote Link to comment Share on other sites More sharing options...
Brody Posted May 24, 2013 Author Share Posted May 24, 2013 Maybe you can pick Smallys brain. He put together a beautiful Move Along. Good Luck. Thanks, I'll check it out Quote Link to comment Share on other sites More sharing options...
iconoclasta_88 Posted May 24, 2013 Share Posted May 24, 2013 Seems that your left side ear might be a bit too much to the front. That might make a huge difference when trying to fit all the stripes. But, it doesnt look too bad. Have you tried to fit the template already? Saludos. Quote Link to comment Share on other sites More sharing options...
Sandman Tigui Posted May 24, 2013 Share Posted May 24, 2013 Juan's got a point... However, I got a ready to go template. Had made 'em in 2 different decal printed transparent paper to see which fitted best for the bucket. Reducing 5%-8% between one and the other. In case you find it helpful could have it PM to you with no worries at all Quote Link to comment Share on other sites More sharing options...
P3laton3 Posted May 24, 2013 Share Posted May 24, 2013 the stripes should be 13 on the right side and 16 on the left one Quote Link to comment Share on other sites More sharing options...
Brody Posted May 24, 2013 Author Share Posted May 24, 2013 Seems that your left side ear might be a bit too much to the front. That might make a huge difference when trying to fit all the stripes. But, it doesnt look too bad. Have you tried to fit the template already? Saludos. That's what I was starting to think. I have tried to roughly fit the templates on, and for both sides, the stripes just wont have enough room. I think that the ATA indentations are a little off, because all I did was drill out on the indentations. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.