Search the Community
Showing results for tags 'ATA Helmet'.
Found 1 result
-
I have searched, read, watched videos, etc. and honestly become a bit compulsive about the stuff that I'm building... I've got the helmet all trimmed except for the eyes and teeth. One side of the helmet matches nicely. The other side is not as good of a fit. The bottom edges don't line up - do I just taper / trim them? Front view: The brow is trimmed almost to the bottom line of the traps - maybe 1/8" inch below Here is a side view. I felt like I was leaving too much on the dome / cap at the bottom but now that it is fit together, I have a notable difference on the bottom edges. Also, this side isn't as snug in the cheek area as the other side. Along the bottom, the tube on the face is misaligned about a half inch compared to the bottom of the dome. Do I trim this or do the ears and neck seal just blend over this? Any advice is appreciated. Sharpie used for scale...I would say about a half inch. The other side - which is a lot more lined up and flush... Bottom view: Do I just need to slide the face up and tilt the cap further back maybe? The magnets are such a pain and slide around so much this was the best I could get last night...
