mark23 Posted July 28, 2019 Share Posted July 28, 2019 I need some guidance for doing the tight armor any good guide or tips tks! Quote Link to comment Share on other sites More sharing options...
Hausi Posted July 28, 2019 Share Posted July 28, 2019 The thigh armor? What advice do you need mate? What kind of armor are you working with? Normally you leave about 8 millimeters from the front edge (keep in mind you will glue on a coverstrip of about 1,6 centimeters in width to join the two halves). I personally test-fitted it first, using some tape to hold those halves together but you can actually glue them together from the beginning, I recommend using E6000, should you mess it up, it's easier to take them apart again. When glued or taped together you put them on and measure where to cut (easier to have someone help you to draw the line where to cut but I actually managed to do it all by myself). Make sure that that line is completely straight and vertical. Some people need to add some additional ABS strips to widen the thighs, depending on one's build. Finally you glue on the back coverstrip (about the same width as the front one). Hope this helps. Cheers mate Quote Link to comment Share on other sites More sharing options...
mark23 Posted July 28, 2019 Author Share Posted July 28, 2019 im really a newbie about armor assembly so im looking at a detailled guide. This is a picture of what the armor model im working on. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.