Marv

Nice that looks sweet.

Sorry links don't work for me

Brilliant bit of work in this agree this could be the likely source. I had brought some aircraft capacitors for my build (when I get back to it) but this feels more likely What model Fender is pictured above?

If they didn't say what vehicle did they say what it is?

For me the exhaust port housing is definitely rounded, have a look at the shadow on the top bottle and compare, look how it is with yours. That said great build if I can get 5 minutes to myself will crack on with mine.

Who's find is the earlier image?

Did you post an image its not showing for me?

Is that last image of a found part or one that has been made looks spot on.

With regards to the seed trays the originals 3 and 5 rib do have holes. I suspect that they actually help hold the parts together.

Sorry but I disagree with point 16, I think this is something out there in the wild though not one piece, but made up of a couple of bits - piped bit and the base. Cobbling something like that would have taken far more effort than to have something at hand. It's just something no one has yet identified.

For me it's a nice pack but if you cannot get anything from the post other than nice shots its not really worthy of being pinned.

Shame there is no build reference shared with this

Please let me know if you have another or better still a up90

How did you dye your straps I've tried a couple of times and it just washes straight out?

Where is this bit on the pack? Is it known what theses pieces are or from?

Meant to post this a little while ago, sorry for the delay Chris:

Will try and get a picture up later to show what I meant

Here you go Chris if you ask seller they'll add more: https://www.ebay.co.uk/itm/1000mL-Widemouth-Dual-Cap-White-Plastic-Chemical-Storage-Case-Bottle-Container/382419368999?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 Also put measurements you were after in the earlier post.

That line denotes where the leather surround starts so I guess it depends how you construct the box as to where you trim If you take the height and width of the plate you have at the line that will give some of the radio dimensions for the box you are trying to construct. The box width is 85mm so I'm guessing +75mm from your line. The leather is 75mm wide, 2mm thick, the stitching is 5mm deep

These are the parts I've managed to accumulate, was lucky and picked up a UP85 last week and my two replacement chemical bottles arrived yesterday, they are definitely a better fit. The Sonix was my first part, otherwise this was going to be a nonstarter.

Chris the dimensions are they for a sonix? If so let me know what you need and I'll let you know what your after

On your frame when the bottom material strap is in place, is the screw accessible for attaching the mortar tube (think that's the right term) or is it covered?

I have to admit I've been thinking along the lines of ties or actually wire as a means of securing it all together, based on the fact that there are holes on the seed trays which lends itself to it, and that wire was obviously used to secure the Sonix too.

I think this illustrates it brilliantly, you don't think it's this way because it's sitting on one of the exhaust port attachments do you perhaps? But even if it were it still doesn't help with how it would be attached to the tray.

Are they glued?