Sn4k3 Posted October 9, 2020 Share Posted October 9, 2020 Hi guys i hope you all are ok I come here to create a thread about how much to cut the plastic part of the belt, on the top, sides and below Does anyone has a reference in mm? From the last block on each side how much do the belt should extend? And on too/below, how close the do the edge should be to the blocks? The photo is my belt as it is right now Btw did you know the the blocks aren't perfectly aligned? Sent from my GM1900 using Tapatalk Quote Link to comment Share on other sites More sharing options...
Hausi Posted October 9, 2020 Share Posted October 9, 2020 All of our gear is wonky as hell and it's good! I think you can sand down the top and bottom edge just a tiny bit more until you're almost where the block begins. For the left and right side, have a look at screencaps: They weren't all the same, so don't worry too much about measurements. 2 Quote Link to comment Share on other sites More sharing options...
Sn4k3 Posted October 9, 2020 Author Share Posted October 9, 2020 All of our gear is wonky as **** and it's good! I think you can sand down the top and bottom edge just a tiny bit more until you're almost where the block begins. For the left and right side, have a look at screencaps: They weren't all the same, so don't worry too much about measurements. Thanks! I'll sand down a bit the top an down and i will get back here with the resultsSent from my GM1900 using Tapatalk Quote Link to comment Share on other sites More sharing options...
troopermaster Posted October 9, 2020 Share Posted October 9, 2020 The plastic ammo belt should be 90mm tall and go 40mm past the end blocks. Those measurements were taken from an original ANH belt. The canvas belt is 70mm tall. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.