Jump to content
Sign in to follow this  
KRISCLON13

TD-64531 Requesting Deployment

Recommended Posts

Great work! Glad to see more and more PO applications come in!

A couple things I noticed that you may need to adjust before your review.

1. Are your gloves the rubber chemical gloves? They appear to be cloth or leather

2. The hand plates, are they hard plastic or the rubber latex kind, need to be the latex, or rubber kind

3. Your rivets on the side of your ab/kidney plate look to be a little large

4. Are your shoulders straps canvas or elastic? They should be elastic

5. It looks like you are missing the srapping system screws on your chest piece.

6. Your shoulder pouch may need to be swapped for a canvas pouch, Im not sure, thats up to the DOs

And in general, I would tone down the weathering in a few spots. Maybe hit the darker patches with some light tan or unbleached titanium white. It will help sell it more as sand and dirt than wet mud. When it comes to Sandtrooper weathering, less is more is the best approach. 

I know it sounds like a lot, but they aren't too difficult, it will make your costume look that much better! Great work! 

Your blasters look great! Love that DLT19!

 

Share this post


Link to post
Share on other sites

As John says. I would also cut the Mortartube a bit. And the E-11 needs more dirt. The shoulder Pouch can be made of leather, why not.

 

Share this post


Link to post
Share on other sites

All in all you have a great kit.  Like @henselmonstersaid, you might have a few changes but nothing too difficult.  Best of luck with your application.

Share this post


Link to post
Share on other sites

this button should be sewn on!

agbqr3iq.jpg

Share this post


Link to post
Share on other sites

Are there washers under the screws? If yes, please remove them.

sowfxnag.jpg

Share this post


Link to post
Share on other sites

Looks better. Note: the diameter of the rivets is 8mm

Share this post


Link to post
Share on other sites

Nice kit! Great to see more PO's..

 The one thing that jumped out to me was your filter. The tubes are a bit too big. They should be closer to .5 cm in diameter. 

 Good luck!! Your well on your way.

f5c97abbe30a0d375aef9aabef26e9f0.jpg

a6144079c2036dfc08f182599652c9c6.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×