Jump to content

*ACTIVATED*TD-31967 SWAT Deployment #37


Old Nic
 Share

Recommended Posts

  • Replies 115
  • Created
  • Last Reply

Top Posters In This Topic

@ Uwe - Sorry about the delay, Brother! We will get you squared asap. Very busy year so far in the Legion, but you know we'll always try to get to our troopers as soon as we are able! :td: :thumbsup:

Link to comment
Share on other sites

  • 2 weeks later...

Hi Uwe,

Thank you for your patience with your SWAT application.

I will be taking on this review from where Mike left off. so Lets continue!...

APPLICATION REVIEW (PART 2)

Name: Uwe Kalb
Legion ID #: TD-31967
Forum Name: Old Nic

Garrison: German Garrison

** ANH SANDTROOPER SELECTED **: "Move along" Captain.






HELMET:

a.) Green Lenses -- See comments
b.) Paint Color on Traps / Tears -- CHECK
c.) Correct Number Of Teeth -- CHECK
d.) Mic Tips -- CHECK
e.) Vocoder Color (Black) -- CHECK
f.) Tube Stripes -- CHECK
g.) Rank Bar (Ears)-- CHECK
h.) Brow -- CHECK
i.) Side Screws (Ears): CHECK

j.) Weathering: CHECK

** Additional comments**

Uwe, I need to bring your attention to the right eye. One of the most noticeable details about the road block Captain's helmet is the "sleepy eye" on the wearers right side.

Notice how the right eye has a little bit of remaining uncut plastic:

ANH_HD_stunt03_zpssgmln5gx.jpg

and here is yours

Old%20Nic%201_zpsph3ajydh.jpg

You'll need to try to replicate this as best you can.


*RESULT ON HELMET*



*Awaiting mods*


II.) Armor / Suit Details:

a.) Canvas / Elastic Straps -- CHECK
b.) Neck Seal -- CHECK
c.) Black Undersuit -- CHECK
d.) Shoulder Bells -- CHECK
e.) Biceps -- CHECK
f.) Forearms -- CHECK
g.) Pauldron -- CHECK
h.) Chest / Back Plate -- CHECK
I.) Kidney / Butt Plate -- CHECK
j.) Ab Plate / Side Rivets / Cod -- CHECK

k.) Thighs -- CHECK
l.) Shins / Calves -- CHECK
m.) Sniper Plate -- CHECK
n.) Boots -- CHECK
o.) Gloves -- CHECK
p.) Hand Plates / Guards -- CHECK
q.) Ammo Belt (Waist) w/ correct Angled Edges -- CHECK
r.) Ammo Belt (Right Knee) -- CHECK
s.) Canvas Belt -- CHECK
t.) Pouches -- CHECK
u.) Weathering -- CHECK




** Additional Comments **

I have checked against Mike's previous comments and am happy with the modifications you have made :thumbsup:

Well done on these!


*RESULT ON ARMOUR*

**CHECKED AND CLEARED**


III.) BACKPACK:

a.) Details -- See comments
b..) Weathering -- CHECK

** Additional Comments **

This is a great looking backpack that is almost SWAT ready! The only modification that will need to be made is to the lower seed trays. Notice how the outer bottom seed tray appears to have slipped down slightly (hence the need for the black tape on set)

Move%20along%20pack_zps2iydm38h.jpg

This should be an easy mod to make :thumbsup:

*RESULT ON BACKPACK*

**AWAITING MODS**



IV.) WEAPON(S): E-11 (Bapty)

a.) Details -- CHECK
b..) Weathering -- CHECK


** Additional Comments **

Since you submitted your application prior to the change of Bapty requirements, I think it only fair to continue with your review with a standard E-11 being allowed ;)





*RESULT ON WEAPON*


** CHECKED AND CLEARED**

Standing by for your completed mods.....

Link to comment
Share on other sites

I did it on my old helmet too.
I closed the eyes from the inside with the masking tape then I made a little layer of Bondo.
Then when it was drying up I used a cutter to refine the shapes.
I won't take long. :thumbsup:

Link to comment
Share on other sites

...

I did it on my old helmet too.
I closed the eyes from the inside with the masking tape then I made a little layer of Bondo.
Then when it was drying up I used a cutter to refine the shapes.
I won't take long. :thumbsup:

...or use a thin abs plastic strip and glue this behind the edge above the eyes. After the drying of the glue use bondo/ fill putty over the segue from the old edge of the eye to the new. But the result is the same as Ruggero has described.

Link to comment
Share on other sites

The Backpack.....

I moved down the top of the box as far as possible till its laying on the frame of the Backpack. (I´ve cut the edges of the top to get this close)

20150426_130045_zpszca7oc9m.jpg

20150426_131934_zpsyfxtmqpb.jpg

20150426_131917_zpsw99jmgsu.jpg

I know this is not 100% accurate but to get there I would need a other pack frame... :ermm:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share


×
×
  • Create New...