Jump to content

*ACTIVATED*TD-77525 / MILO / SWAT OFFICER # 029


Milo
 Share

Recommended Posts

Name: HIDEKI SHIMA
Legion ID #: TD-77525
Forum Name: Milo

Garrison: Japanese Garrison
Trooper Emulated: Sergeant Desert

Helmet-Off
01_zpsbe6ca328.jpg

Helmet-On
02_zps778f7bf5.jpg

03_zps16b9f68c.jpg

04_zpsb5edde90.jpg

05_zpsb41c57f0.jpg

06_zpsac5d55f3.jpg

07_zpsa3e4e1c0.jpg

08_zps2c917fec.jpg

Action
10_zpsd5f5c648.jpg

11_zps48632674.jpg

Link to comment
Share on other sites

  • Replies 79
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Milo, the only thing that jumps out right quick is the ammo belt. It appears in the pics the belt appears wide. If that makes since. Like it needs cut down a bit on width. Also the weathering? Not sure. Can you post reference pics?

This is for SWAT, so particulars are a must.

Best of luck, you'll get there.

Link to comment
Share on other sites

Milo, the only thing that jumps out right quick is the ammo belt. It appears in the pics the belt appears wide. If that makes since. Like it needs cut down a bit on width. Also the weathering? Not sure. Can you post reference pics?

This is for SWAT, so particulars are a must.

Best of luck, you'll get there.

Hi Jay-san,

Thank you for advice. I'll take a pics of ammo belt tonight. Japan is morning now :)

Link to comment
Share on other sites

Milo, sorry. Misunderstanding. The ammo belt on your waist.

The amount of plastic above and below the boxes appears to need to be narrowed.

I will attach a pic to advise what I mean.post-1737-0-35015700-1404299533_thumb.jp

Let's see what Mike says first.

Link to comment
Share on other sites

Hi Jay, Thanks again!
no problem. It's my misunderstanding :no:

My Belt
61_zps654ee3ba.jpg

I checked screen used armor.

62_zpsd4e7d3c7.jpg

I did not notice. I think my belt and thick as you say  :)
I wait Mike's first check. If I have to cut the belt, I will cut the belt soon ;)

thank you for the advice Jay san


Link to comment
Share on other sites

@ Hideki...

Thank you for your interest in joining the Elite and submitting your request for SWAT OFFICER Activation.

During this process, there may be some mods that will need to be taken care of. Details that need to be even more fine tuned in comparison to past SWAT members. The bar is always being set higher.



As stated before, we always stress PATIENCE during this process as we pay more and more attention to fine tuning with each new SWAT applicant. The MEPD Senior Commanders and myself will give your armor / gear a full inspection and review. Some details may definitely be missed and re-checked, but we will try to catch them on every pass given until you are cleared and ready to join the Special Weapons & Tactics Team, Brother! :td::thumbsup:

With that said, let's begin...





MEPD SWAT OFFICER: APPLICATION REVIEW (PART 1)

Name: Hideki Shima
Legion ID #: TD-77525
Forum Name: Milo
Garrison: Japanese Garrison


** ANH SANDTROOPER SELECTED **: DESERT SERGEANT / "LOOK SIR, DROIDS"


I.) HELMET:

a.) Green Lenses --
CHECK
b.) Paint Color on Traps / Tears -- CHECK
c.) Number Of Teeth -- CHECK
d.) Mic Tips -- CHECK
e.) Vocoder Color (Black) -- CHECK
f.) Tube Stripes -- CHECK
g.) Rank Bar -- CHECK
h.) Brow -- CHECK
i.) Side Screws (Ears): CHECK
j.) Weathering: (SEE COMMENTS)


** Additional Comments --

A.) DEPLOYMENT OFFICER:


First off, this is a fantastic looking helmet! :thumbsup:

1.) Add a few of the weathering details that are missing from your bucket using the reference pis below and you will cleared for this section.

Nice work!

205715_481302308578178_878396963_n.jpg




B.) EXECUTIVE OFFICER: (Comments Pending)



C.) COMMANDING OFFICER: (Comments Pending)


II.) Armor / Suit Details:

a.) Shoulder Straps --
(SEE COMMENTS)
b.) Neck Seal -- CHECK
c.) Black Undersuit -- CHECK
d.) Shoulder Bells -- CHECK
e.) Biceps -- CHECK
f.) Forearms -- CHECK
g.) Pauldron -- CHECK
h.) Chest / Back Plate -- CHECK
I.) Kidney / Butt Plate -- CHECK
j.) Ab Plate / Side Rivets / Cod -- CHECK
k.) Thighs -- CHECK
l.) Shins / Calves -- CHECK
m.) Sniper Plate -- CHECK
n.) Boots -- CHECK
o.) Gloves -- CHECK
p.) Hand Plates / Guards -- CHECK
q.) Ammo Belt (Waist) w/ correct Angled Edge -- CHECK
r.) Ammo Belt (Right Knee) -- CHECK
s.) Canvas Belt -- CHECK
t.) Pouches -- CHECK
u.) Weathering -- (SEE COMMENTS)
v.) Crotch Snaps -- CHECK


** Additional Comments --


A.) DEPLOYMENT OFFICER:


Very nice armor and gear, Troop!

A couple of things...

1.) White elastic material for the shoulder straps will now be required for SWAT.
2.) As stated in the helmet section, Add a few of the weathering details that are missing from your bucket using the reference pis below.

1234174_565518170156591_511590974_n.jpg

402535_452370528138023_794876241_n.jpg

527755_437889092919500_1540206753_n.jpg

1391608_593688364006238_1953083949_n.jpg

B.) EXECUTIVE OFFICER:(Comments Pending)



C.) COMMANDING OFFICER: (Comments Pending)





III.) BACKPACK: VERSION # 3

a.) Details -- (SEE COMMENTS)
b..) Weathering -- CHECK


A.) DEPLOYMENT OFFICER:

Awesome pack!

Again, A few things of note...

1.) The shotgun shells need to be tweaked a bit (positioning wise)
2.) For this review (and in light of new findings), we are going to say no lab pipe.
3.) You don't have to replace your radar dish, but we request that you repaint it with an opaque white/off white and re-weather.




06_zpsac5d55f3.jpg

27_zps1b532369.jpg

A08F82C2-FE26-4A1F-AE02-1213E5530CB5-127

sandtrooper_hd_0362.png

27A6BB41-B98E-476E-9E76-5C562843B412_zps

1237881_565513400157068_883504488_n.jpg

7845_568307209877687_1789332196_n.jpg?oh







C.) COMMANDING OFFICER: (Comments Pending)



IV.) WEAPON: E-11

a.) Details --
CHECK
b..) Weathering -- CHECK

** Additional Comments --

A.) DEPLOYMENT OFFICER:

Excellent looking blaster. Nothing more to say here.



**CHECKED & CLEARED**






B.) EXECUTIVE OFFICER: (Comments Pending)



C.) COMMANDING OFFICER: (Comments Pending)

**REVIEW STILL IN PROGRESS...

Link to comment
Share on other sites

Hi Jay, Thanks again!

no problem. It's my misunderstanding :no:

My Belt61_zps654ee3ba.jpg

I checked screen used armor.

62_zpsd4e7d3c7.jpg

I did not notice. I think my belt and thick as you say  :)

I wait Mike's first check. If I have to cut the belt, I will cut the belt soon ;)thank you for the advice Jay san

Great Milo, I was hoping you was seeing it. It's a very easy fix and it does help draw the eyes away from it, narrowing it a bit. I remember I did it with mine. Your choice though.

Lookin good! Just take care of the little things and you'll be in the SWAT soon enough.

Link to comment
Share on other sites

Thanks for the checking my armor :) I will fix some problems... Weathering, Back pack detail, Shoulder strap...

Thank you for the a lot of reference pics.

Link to comment
Share on other sites

Hi Milo,

nice to see a new Davin on the SWAT road!

Just two little comments from my side:

Look at this Picture. There is a Little band of elastic attached on the pauldron

7845_568307209877687_1789332196_n.jpg?oh

Here is my solution

IMG_1267_zps575d25ce.jpg

and you see that the pauldron is painted white on the back side...don't ask why:-)

Otherwise your pauldron is already checked...so my comments are just for your accurate dark side:-)

Take care and cheers,

Felix

Link to comment
Share on other sites

Hi Felix,

Thanks for the comment. Cool! Little band. It is accurate.

I painted the back of the pauldron. Please refer to the pic. It looks to light color.

Thanks again :)

post-5718-140437005605_thumb.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share


×
×
  • Create New...