Jump to content

Jas' DLT-19 kit Build


Recommended Posts

In my opinion, quite a bit. There was a lot of air bubbles and a bad mismold of the trigger guard. I have used an epoxy putty to fill and rebuild where necessary. It's been nothing hard but time consuming. I will prime grey and then go back and fill any small holes I missed and clean up any other small issues. On the plus side, the detail is very nice, and it is a rubber resin so seems to be very durable. I feel it is a very good value kit.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...